3D drawing software - Main window menu and general commands tutorial (Video currently only available in french language).
Tutorial that describes the menu and general commands of the main window of the 3D drawingsoftware.
This video is completed by the ftwo videos below on this page which describe the use of 3D drawing commands themselves.
This video is completed by the ftwo videos below on this page which describe the use of 3D drawing commands themselves.
3D drawing software - Drawing software basic commands tutorial - Part 1 (Currently only available in french language).
This tutorial describes the basic drawing commands of the 3D drawing software.
It is advisable, before watching this video, to watch the video "Main window menu and general commands tutorial" or to read the documentation.
This video describes in particular:
- The creation of a primitive solid: sphere, cube, cylinder, cone, prism, pyramid
- The use of rules
- The use of the drill, of the saw and of the glue
This video is followed by the video "Drawing software basic commands tutorial - Part 2" which describes the drawing commands that are not addressed in this video.
It is advisable, before watching this video, to watch the video "Main window menu and general commands tutorial" or to read the documentation.
This video describes in particular:
- The creation of a primitive solid: sphere, cube, cylinder, cone, prism, pyramid
- The use of rules
- The use of the drill, of the saw and of the glue
This video is followed by the video "Drawing software basic commands tutorial - Part 2" which describes the drawing commands that are not addressed in this video.
3D drawing software - Drawing software basic commands tutorial - Part 2 (Currently only available in french language).
This tutorial describes the basic commands of the 3D drawing software.
It is advisable, before watching this video to watch the video "Drawing software basic commands tutorial - Part 1" or to read the documentation.
This video describes in particular:
- The design of polygonal curves, free curves and gear shaped curves
- The use of curves to produce a solid: right, guided or ring thickening
- Production of a solid hull from a frame made of currves
It is advisable, before watching this video to watch the video "Drawing software basic commands tutorial - Part 1" or to read the documentation.
This video describes in particular:
- The design of polygonal curves, free curves and gear shaped curves
- The use of curves to produce a solid: right, guided or ring thickening
- Production of a solid hull from a frame made of currves